MATERIAL SAFETY
DATA SHEET |
|
| Manufacturer's Name: MULTICOAT
CORPORATION |
Date prepared or revised: June 28, 2000 Information Telephone No |
SECTION I - PRODUCT IDENTIFICATION |
Chemical name: |
SECTION II - HAZARDOUS INGREDIENTS |
|||
| May contain the following: | |||
| CHEMICAL NAME | CAS NUMBER | EXPOSURE
LIMITS IN AIR (Give Units) |
|
| Ammonia Propylene Glycol Preservative Coalescent |
7664-41-7 57-55-6 4080-31-3 25265-77-4 |
25 ppm |
50 ppm |
SECTION III - PHYSICAL DATA |
||
| Melting Point/Freezing Point: | Boiling Point: | Specific Gravity (Water = 1): |
| 0°C/32°F (Water) | 100°C/212°F (Water) | 1.6 to 1.8. |
| Evaporation Rate (Butyl Acetate = 1): | Solubility in Water: | Vapor Pressure: |
| Less than 1 (Water) | Dilutable Aqueous Dispersion | 7mm Hg @ 20°C/68°F |
Appearance and Odor: White or colored plaster, mild ammoniacal or acrylic odor. |
||
SECTION IV - FIRE AND EXPLOSION HAZARD DATA |
| Flash point: Not Applicable Auto Ignition Temperature: Not applicable Extinguishing Media: Material is not combustible. Use Water. Splatter: The wet dispersion will splatter above 100°C/212°F (Boiling point of water). Special Firefighting Procedures: Firefighters should be equipped with self-contained breathing apparatus and full protective gear. |
SECTION V - HEALTH HAZARD DATA |
||
| ROUTE(S) OF ENTRY: Inhalation - Vapor or mist can cause headaches, nausea, and irritation of the nose, throat and lungs. Skin Contact - May be irritating upon repeated or prolonged contact. Wash skin with soap and water after contact. Eye Contact - Flush eyes with large amount of water for at least 15 minutes. Consult physician if irritation persists. HAZARD RATING (NFPA 704) HEALTH EFFECTS The effects of over-exposure are based on acute toxicity profiles for a number of acrylic emulsions that are compositionally similar to the binder used in this product. |
||
| Typical values are: | Rate, oral LD50: Rabbit, dermal LD 50 Rabbit |
>5.0 g/kg >5.0 g/kg Eye irritation |
| Acute effects: Chronic effect: |
Non-toxic by ingestion. May cause
eye and skin irritation No known chronic health effects |
|
| FIRST AID/EMERGENCY PROCEDURES Eye Contact: Flush eyes immediately with running water for 15 minutes, including under eyelids. Consult a physician if irritation persists. Skin Contact: Wash with soap & water. Inhalation: Move subject to fresh air. If breathing is difficult consult a physician. Ingestion: Dilute with large amounts of water and consult physician. SUSPECTED CANCER AGENT? NO This product's ingredients are not found in the Federal OSHA, NTP, IARC California employers using CAL-OSHA - regulated carcinogens must register with CAL-OSHA. CAL-OSHA and Federal OSHA carcinogen lists are similar. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None other than the above listed. |
||
SECTION VI - REACTIVITY DATA |
| Stability: Stable. Incompatibility: None Hazardous Polymerization: Will not occur. Conditions to Avoid: None known |
SECTION VII - SPILL, LEAK AND DISPOSAL PROCEDURES |
| Spill response procedures (Include employee
protection measures): Normal clean up precautions of Section VII. Preparing wastes for disposal (container types, neutralization, etc.): May be salvaged for use or removed to a landfill dump in accordance with regulations. |
SECTION VIII - SPECIAL PROTECTION INFORMATION |
|
| Ventilation and engineering
controls: Provide general ventilation and local exhaust ventilation to remove vapor or mist in confined spaces. Respiratory Protection (type): NIOSH approved respirator. Eye Protection (type): Approved tight-fitting safety goggles or glasses. Glover (specify material): Gloves/Rubber. Other clothing and equipment: Clean, body-covering protective clothing, such as long-sleeve shirt with buttoned collar, long pants extending over tops of work shoes. Work practices, hygienic practices: Keep work area clean to avoid creating excessive dust. STORAGE & HANDLING: |
|
| Storage temperature: | Maximum 30°C/85°F Minimum 4°C/40°F |
| KEEP FROM FREEZING - PRODUCT WILL
COAGULATE Protective measures of contaminated equipment: None other than listed above. The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use thereof. Multicoat Corporation assumes no responsibility for personal injury or property damage to vendees, users or third parties caused by the material. Such vendees or users assume all risks associated with the use of the material. |
|
back to MSDS SHEETS
| back to
Home Page please fill out our Feedback
Form |
Copyright
© 2005 Multicoat Corporation. All rights reserved. |